Skeletor MK7 Topless Strain Relief & Tophat — Physical

🚢Shipping

• At this current time shipping is only available in the U.S.

🔧 Configure Your Topless Kit (Variants)

• X-Carriage: Stock / BCJ / HDM

• Topless Strain Relief Branding: MK7 branded / TBK branded

• Tophat Emblem: “Skeletor” wordmark / “Skeletor Skull” emblem

• Cable Management: Zip-Tie Tab / No Zip-Tie Tab

• Accent Color (Tophat/trim): Black / Red / Green / Blue

• Kit Contents:

  • Standard — Inserts Installed · One complete Topless set with threaded heat inserts pre-installed

  • Standard + Spare Parts — Extra Printed Set (No Inserts) · You’ll receive the Standard kit plus an extra printed set without heat inserts (see exact spare contents below)

⚠️Important

— HDM Rail Compatibility
If you run HDM rails, use the updated Skeletor X-Carriage for HDM (post-September 1 update). Older HDM X-Carriage versions are not compatible with this mod.

—If you choose the zip-tie cutouts, the mount supports toolhead cable bundles up to 7.5 mm (~0.295″) in diameter; without the cutouts, the maximum is 5.5 mm (~0.217″).⚠️

📦 What’s Included

• Standard — Inserts Installed

  • Topless Strain Relief (selected branding) — heat inserts pre-installed

  • Carriage-Mounted Tophat (selected emblem, accent color, and chosen cable-management option)

  • Mounting hardware matched to your selected X-carriage variant

• Standard + Spare Parts — Extra Printed Set (No Inserts)

  • Everything in Standard, plus:

    • Topless Strain Relief (matching your selection) — 1× spare (no inserts)

    • Tophat (matching your selection) — 1× spare

    • Tophat (blank zip-tie variant, no emblem) — 1× spare, sized for cable bundles up to 10 mm Ø

  • No additional hardware is included with the spare set

• Color/Material: Black ABS

🧩 Compatibility

• Platforms: Creality K1 / K1 SE / K1C / K1 MAX

• Requires: Skeletor MK7 installed (this add-on replaces the standard MK7 strain relief)

• Cable Chain: Intended for chain delete; chain-keep paths are covered in the guide

🧰 Install Overview

1. Remove the standard MK7 strain relief.

2. Install the Topless Strain Relief and Tophat to the specified carriage points.

3. Route wiring per guide; verify full-travel clearance on X/Y before printing.

📖 Setup & Usage Guide

• Topless Strain Relief & Tophat — Setup & Usage Guide (link on this page)

• Strongly recommended: review an MK7 setup & usage guide first—this add-on assumes familiarity with MK7 basics.

💡 Bundles & Savings

Bundle discounts are available when you add one or more accessory to your Skeletor MK7 — Physical Kit purchase. Qualifying carts receive the savings automatically at checkout (no code needed).

📸 Share Your Build

Post your photos to the Skeletor Collection on Printables and check out other makers’ builds.